Some screws are turned by hand, others lost their head, and one looks like a sea monster. It might be time you read up on your screw heads.

1. Lay four of the 600mm boards flat on the workbench and, keeping the assembly square, screw two of the posts at each end and one centrally, with two screws into each board. Repeat for the sides ...

A countersink is often essential when working with screws to ensure the head of the screw is flush with the surface.

Dirt consistent with that found in the vicinity of the accident site was identified on the elevator, as well as in the counterbore and threaded area where the counterweight plug would have been ...

Hot-dip galvanised bolts were left visible and unplugged but set into shallow counterbores to ensure some finesse when using these more agricultural-graded fixings. Similarly, galvanised brackets that ...

Drill pilot holes with a countersink bit through the top and bottom boards. Apply glue to the ends of the side boards, then flush the boards up and fasten them together with screws.

Is there an existing issue for this? I have searched the existing issues Problem description When drilling holes in PartDesign, if hole has a cut type (counterbore, countersink, etc) and hole is th ...

In order to promote public education and public safety, equal justice for all, a better informed citizenry, the rule of law, world trade and world peace, this ...